Apparently PoP! doesn’t support Secure Boot. No idea why the system still runs and works apart from loading nVidia drivers though

Issue found: I disabled secure boot from BIOS and now I can change resolution and refresh rate. Thanks for the help!

Issue found: I disabled secure boot from BIOS and now I can change resolution and refresh rate. Thanks for the help!

Checked it just now and yes it’s properly seated. Checked power cables too and those are good as well. Cleared CMOS and now display defaults to 1024*768 resolution with no way to change it lol

Currently using 12GB for system and 9GB for apps, then I have 30GB for music + documents + backups (that I mirror on PC) since I never stream anything, so 64GB would be a bit too tight for me haha

I keep the bare minimum on my phone (something to read, music) and use very few apps, so 64GB could be enough for me, but I have other requirements for my phone and those often collide with storage so I never find anything with less than 128GB.

I keep backups on my PC, and that’s where I funnel my funds for storage lol

Teach me your ways. I don’t have a very new model, I think it’s a 4130e or something. Do you use CUPS?

My issue lies elsewhere, it takes me that long to have the printer recognized by the OS, then by CUPS browser, then I send the printing job and… it just stalls, never prints. I then cycle the USB ports and start all over again until it miraculously prints

I have a HP printer and printing is never a smooth process. No idea why, but it takes me 5/10 minutes each time

Hell yea