You and I and everyone on Lemm are a rounding error.

There was also no reddit migration.

The amount of waste and time it takes are downright insulting

Small steps like what? There’s no small steps in changing lifelong OS

I did, check my comment.

Completely new and dried for 24 hours in a dedicated dryer. Thanks.

SOLUTION: runs contrary to common knowledge, but what ultimately helped was:

• INCREASING print speed. The usual recommendation is the slower the better, but at that point, there’s no pressure control over the filament
• ENABLING retraction. Again, usual rec is to disable it for flexibles but turns out it alleviates too much backpressure which leads to filament buckling in the extruder

Also printing hotter than mfg recommends: I printed at 260 (10C over recommended maximum).

Thanks to u/Over_Pizza_2578 for pointing me to the right - opposite to everything else - direction.

Yes, this is probably adding to the situation.

I’m in the same boat. I’d like to have something like this integrated with Home assistant but Grocy is just ludicrously complex. It’s like SAS for your fridge, only more complex. With rude developers who always know better than everyone else.

This may be overkill but try Piped.video

It removes all tracking and ada frok youtube and allpws you to import your subscriptions.

I have absolutely no idea how Brave got the reputation it has. It’s business model is disgusting and extortionate, it’s like paying for warez. Been clear as day since day one.

For me the responsivity of Klipper UI was reason enough. Octoprint is unbelievably slow on the same hardware. The other thing was ease of configuration - no firmware compilation and flashing necessary. And the third is the actual printing performance - Octoprint has a really bad implementation of the actual print data transfer, and the serial interface routinely chokes on fine data such as arcs. That never happens with Klipper, even at much, much higher print speeds.

VM or container? VM is easier and can be usually configured even via Proxmox GUI (Hardware - Add PCI). Various OSes need various levels of effort. Some Linux distros don’t need any more config, Windows on the other hand required a custom GPU ROM on my system to work.

This can be done even with a single GPU, even the built in iGPU.

No

I’ll probably buy more of this pink ABS, I find it very pretty

So you use the free thing wrong, don’t RTFM, vent on internet and then vent some more when corrected? What’s your end game?

She does ❤️ thanks :)

Looks like an user error to me. Influx is for long-term storage of history and data, you don’t need it for automation at all.

Absolutely wrong. I have dozens of devices integrated, from a lot of brands, all working. You can of course try to get a turnkey solution from like Loxone, but be prepared to pay thousands of dollars, and good luck adding anything that’s not in their ecosystem. And there’s a lot of that. And what is there is all pretty outdated.

Xiaomi is great and I use a lot of their stuff, but the options for automation are severely limited.

Exactly :)