check that comment there’s new response

I checked, ollama does not use npu

ah that’s good

which software exactly (that uses npu instead of gpu)?

I have heard of ollama before, is this the same thing?

on ios it can be achieved with shorcuts, not sure about android

I found this too, but bidirectional support is important to me. I’m also not sure how it would work between Android and iOS.

https://reddthat.com/post/59164025

WebRTC isn’t magic. WebRTC does not bypass a VPN, nor is it the only–or even most common–way that software on your phone, Android or otherwise, can exfiltrate potentially sensitive information, intentionally or unintentionally. The way WebRTC on your phone might leak an IP is that during ICE, which is used by more than just WebRTC, the phone’s local IP addresses may be sent, and IPv6 addresses on your WiFi or cell connection may be globally unique. IPv4 local addresses will almost certainly be meaningless, private addresses due to IPv4 address space exhaustion, and any non-local address will be from your VPN gateway.

You cannot block ICE per app or system wide because it is not a system facility, and the permissions required to implement it on Android are not very specific.

I think what @[email protected] meant is block connections without vpn is enough. though I’m not quite sure

Thanks. WebRTC-related IP leaks can occur when using a proxy. I’m searching for a method to disable WebRTC per application or across the entire system when using VPN

thanks a lot

that seem nice

thanks. you may also want to take a look at https://lemmy.ca/post/38746526

I use jellyfin and it doesn’t seem to have this function. More importantly I would also like to keep notes for movies that is not downloaded and not shown in jellyfin

Could you explain more please? How can we keep notes inside nfo?

thanks a lot

thanks a lot

it is still under 192.168.8.0/24

Thank you, a short reset worked!

But how do I set up the routing correctly on the WireGuard router? What should the Target Address and Gateway be if my LAN is under 192.168.8.0/24, and my mobile client with the WireGuard client has a client IP of 10.0.0.2/24?

Thank you, a short reset worked!

But how do I set up the routing correctly on the WireGuard router? What should the Target Address and Gateway be if my LAN is under 192.168.8.0/24, and my mobile client with the WireGuard client has a client IP of 10.0.0.2/24?

Thank you. Looks very similar to https://github.com/FuzzyGrim/Yamtrack